D9412GV4/D7412GV4/D7212GV4 SDI2 Modules | en 187
Bosch Security Systems, Inc. Program Entry Guide F.01U.218.312 | 04 | 2012.03
Keypad Programming of Unit Hostname
D1255
1. Refer to Section 2.5.1 Keypad Programming Menu, page 12 to access the TOOLS MENU
and navigate to the PROGRAMMING option.
2. Press [ENT] to enter the PROGRAMMING option.
3. Press [ENT] at the DNS PARAM option to enter it.
4. Press [ENT] at the MODULE HOSTNAME option. The currently configured hostname
shows. An invisible editing cursor is enabled for the first byte.
5. The [PREV] button acts as a [Backspace] key. The [COMMAND] key allows you to cycle
though the special passcode characters (A, B, C, D, E, F); the [NEXT] key selects the
passcode character.
6. Press [ENT] to save the changes.
D1260
1. Refer to Section 2.5.1 Keypad Programming Menu, page 12 to access the Tools Menu and
navigate to the Programming option.
2. Press [ENTER] to enter the Programming option.
3. Press [ENTER] at the DNS Parameters option to enter it.
4. Press [ENTER] at the Module Hostname option. The current configured hostname shows.
5. To change the setting, press the Edit softkey. An invisible editing cursor is enabled.
6. Use the softkeys and the number buttons on the keypad to enter the new passcode. The
Backspace softkey allows you to erase characters. The Clear softkey allows you to clear
the entire passcode. When entering a letter character, press the letter’s softkey to select
it. The Previous and Next softkeys advance through the letter characters (A, B, C, D, E,
F).
7. Press the Save softkey to save the changes.
Unit Description
Use this parameter to create a unit description.
Local Port Number
Keypad Programming of Local Port Number
D1255
1. Refer to Section 2.5.1 Keypad Programming Menu, page 12 to access the TOOLS MENU
and navigate to the PROGRAMMING option.
2. Press [ENT] to enter the PROGRAMMING option.
NOTICE!
Each display can be programmed with up to sixteen alphanumeric characters, including: A to
Z, 0 to 9, -. Characters not listed are invalid and cannot be used.
Default:Blank
Selection: Sixty-four alphanumeric characters
NOTICE!
The description can be programmed with up to sixteen alphanumeric characters, including: A
to Z, 0 to 9, ?, &, @, -, *, +, $, #, _, /.Characters not listed are invalid and cannot be used for
text.
Default:Blank
Selection: Twenty alphanumeric characters
Default: 7700
Selection: 0 to 65535
To Next Page
Loading...
