Bosch D7412GV4 - Page 37

D9412GV4/D7412GV4/D7212GV4 Panel and Area Wide Parameters | en 37
Bosch Security Systems, Inc. Program Entry Guide F.01U.218.312 | 04 | 2012.03
Table 3.10 Diagnostic Reports
Relay Reports
Selecting Yes enables sending a report when the event occurs.
Report Selections Report Description
R# SDI Device Fail
1
Yes, No SDI device failure
R# SDI Device
Restoral
Yes, No Restoral of SDI device failure
R# Watchdog Reset Yes, No Watchdog Reset Event
R# Parameter
Checksum Fail
Yes, No Parameter checksum failure
R# Reboot Yes, No Reboot Event
R# Phone Line Fail
1
Yes, No Failure of phone line
R# Phone Line
Restoral
Yes, No Restoral of phone line afterfailure
R# AC Fail
1
,
2
Yes, No Failure of AC power to control panel
R# AC Restoral
2
Yes, No Restoral of AC power to control panel after failure
R# Batt Missing
1
,
2
Yes, No Battery Missing Detection Event
R# Battery Low
1
,
2
Yes, No Low battery power
R# Battery Restoral
2
Yes, No Restoral of battery power to control panel after Missing
or Low Event
R# Rt Comm Fail
1
,
3
Yes, No Failure to send report to specific route
R# Rt Comm Restoral Yes, No Restoral of communication to specific route after a
failure
R# Rt Comm Restoral Yes, No Restoral of communication to specific route after a
failure
R# Checksum Fail Yes, No Checksum Fail Event
R# Network Fail
4
Yes, No Failure of network
R# Network Restoral
4
Yes, No Restoral of network
R# Network
Condition
4
Yes, No Condition of network
R# RF Interference Yes, No RF receiver interference
R# RF Interference
Restoration
Yes, No RF receiver communication restored
R# Equipment Fail Yes, No Trouble on SDI2 device
R# Equipment Fail
Restoration
Yes, No Restoration of trouble on SDI2 device
1
This event is included in the Expanded Test Report when an off normal condition exists.
2
To meet UL 864 requirements for Central Station and Remote Station applications (D9412GV4 and
D7412GV4), enable AC Fail, Battery Missing, Low Battery, Battery Restoral, and AC Restoral reports.
3
This event covers Comm Fail Route Group and Comm Fail Phone. If enabled, both events are sent; if
disabled, neither event is sent.
4
This event is reserved for future use.
NOTICE!
Enable Rt Comm Fail and Rt Comm Restore in only one route group.
Report Selections Report Description
R# Sensor Reset Yes, No Sensor Reset Event
R# Relay Set Yes, No Relay Set Event
R# Relay Reset Yes, No Relay Reset Event