Bosch eBike Active Line BDU310 - Page 169

161
5.13 Error Codes 5.13 Error Codes
PowerPack Classic+ Line
error code
in DiagnosticTool
error code
in display
Error description, repair
0x02 00 02
0x02 00 13
0x02 00 0F
200
Error in battery: Excess current (... 13), electronics (... 02) or short circuit
(... 0F). Contact Bosch Service Hotline.
0x02 00 05
0x02 00 22
0x02 00 23
203
CAN-Communication problem between battery and other system compo-
nents. Check wiring and contacts.
Also possible: Battery removed without powering off system.
0x02 00 12
0x02 00 17
201
Temperature in the battery above permissible maximum. Switch off the
system and wait at least an hour until the temperature has dropped to the
normal level.
0x02 00 19 202
Temperature in the battery under permissible value. Turn off the system
and wait at least an hour for the battery to warm up to the normal level.
0x42 30 11 423
Communication problem between battery and other system components.
Check wiring and contacts.
0x02 00 20 204
Battery management system detects incorrect charging current. Replace
the charger. Only use the original charger for charging.
Nyon, Intuvia, Purion
error code
in DiagnosticTool
error code
in display
Error description, repair
0x410015 410
Error on display key. Check whether keys are blocked. If the error persists,
replace the on-board computer.
0x414014 414
Error on remote control. Check wiring. If the error persists, replace the
remote control and the socket.
0x418016 418
Error on remote control. Check whether keys are blocked. If the error
persists, replace the remote control.
0x419001 419
Incorrect software variant. Print diagnostic report, clear error code,
update software, restart system. If the error persists, replace on-board
computer.
0x419002 419
Unknown hardware version. Print diagnostic report, clear error code,
update software, restart system. If the error persists, replace on-board
computer.
0x419003 419
Incorrect hardware variant. Print diagnostic report, clear error code,
update software, restart system. If the error persists, replace on-board
computer.
0x422010 422 Drive-unit communication error. Check wiring and connections.
0x423011 423 Battery communication error. Check wiring and connections.
0x424012 424
Internal communication error. Check wiring and connections. If the prob-
lem persists, try another board computer and other socket on the PC.
0x426001 426 Internal timeout error.
0x430013 430
Internal board computer battery empty. To charge the internal battery of
the on-board computer, connect the display to the power source using the
micro-USB jack and turn on the system with the "On / Off" button on the
battery pack. If fault persists after recharging, replace the on-board com-
puter.
5
SERVICE