Bosch eBike Active Line BDU310 - Page 176

168
5.13 Error Codes
5.13 Error Codes
CapacityTester
error code
in DiagnosticTool
error code
in display
Error description, repair
0xA43000 –
Internal discharge error. Print the diagnostic report, clear the error, and
restart the device. Perform software update.
0xA44000 –
Internal hardware error. Print the diagnostic report, clear the error, and
restart the device. Perform software update.
0xA51000 –
The measured discharge current is too high. Use a second battery for
swap-testing. Check cable and battery connector. Print the diagnostic
report, clear the error, and restart the device. Perform software update.
0xA52000 –
The measured discharge current is outside the permissible range. Use a
second rechargeable battery. Check cable and battery connector. Print the
diagnostic report, clear the error, and restart the device. Perform software
update.
0xA53000 –
Internal hardware error. Use a second rechargeable battery. Print the diag-
nostic report, clear the error, and restart the device. Perform software
update.
0xA54000 –
Internal hardware error. Print the diagnostic report, clear the error, and
restart the device. Perform software update.
0xA55000 –
The measured discharge current is too high. Use a second rechargeable
battery. Check cable and battery connector. Print the diagnostic report,
clear the error, and restart the device. Perform software update.
0xA56000 –
The measured discharge current is outside the permissible range. Use a
second rechargeable battery. Check cable and battery connector. Print the
diagnostic report, clear the error, and restart the device. Perform software
update.
0xA57000 –
Internal hardware error. Use a second rechargeable battery. Print the diag-
nostic report, clear the error, and restart the device. Perform software
update.
0xA58000
0xA59000
0xA5A000
0xA5B000
0xA5C000
0xA5D000
–
Internal hardware error. Print the diagnostic report, clear the error, and
restart the device. Perform software update.
0xA61000 –
USB protocol error. Connect the CapacityTester to another USB port using
another USB cable. Print the diagnostic report, clear the error, and restart
the device. Perform software update.