Broadcom NetXtreme - Page 115

Broadcom NetXtreme Ethernet Adapter • Diagnostic User’s Guide
page 115
Broadcom Confidential and Proprietary
-m Generate TPROT packets
-n<DEC> Number of packets to be transmitted (def=0)
-o<DEC> Number of Rx Rings (def=1)
-p Send protocol packets configured with txcfg command.
-q Use software CRC-32 on Tx Path
-r Enable Rx
-s Stop on Failure
-t Enable Tx
-u Ignore VLAN tag in frame when in Host Loopback mode
-v<HEX> Random packets test 1:random packet size. 2: random burst length.
4: random burst gap. 7: random all above.
-w<DEC> Low watermark max RxFrame value (0-65535)
-x Check length of received packet
-z<DEC> Tx Threshold (def=5)
-B<HEX> IPSEC cipher ID incremental tst start cipher_id (def=0)
-E<HEX> IPSEC cipher ID incremental test end cipher _id
-F<HEX> IPSEC enabled, with cipher_id (hex) (def=0)
-G<HEX> IPSEC random test. 1: mix non-IPSEC/IPSEC packets. 2: random
GCM/GMAC salt. 4: random encryption/authentication keys.
7:random all above.
-H<HEX> IPSWC packets percentage if –G1 options is added (def=50)
-M<HEX> Payload size (def=4).
-N No statistics polling
-O<DEC> For 5761 only, specify the polling interval ( 1-1000 ms) (def=500).
-P Pause
-Q<DEC> Wait 0.x seconds, then ESC from blast (def=1).