Broadcom NetXtreme - Page 41

Broadcom NetXtreme Ethernet Adapter • Diagnostic User’s Guide
page 41
Broadcom Confidential and Proprietary
-ppxe <filename> Program PXE firmware
This option needs to follow the –e and –c options. If this option is entered, the program will
retrieve the PXE firmware filename from the command line then it will start programming.
Example:
b57diag –e <code> -c 0 –ppxe b57pxe.bin
-mba <value> Enable/Disable Multiple Boot Agent
A value of 1 will enable Multiple Boot Agent and a 0 will disable.
Example:
b57diag –mba 0 : Disabling mba.
-mbap <value> Select Multiple Boot Agent Protocol
value = 0 : Selecting PXE
value = 1 : Selecting RPL
value = 2 : Selecting BOOTP
Example:
b57diag –mbap 0
-mbas <value> Select Multiple Boot Agent Speed
value = 0 : Selecting Auto
value = 1 : Selecting 10HD
value = 2 : Selecting 10FD
value = 3 : Selecting 100HD
value = 4 : Selecting 100FD
Example:
b57diag –mbas 0 : To select Auto speed mode.
-pxes <value> Select Multiple Boot Agent Speed
value = 0 : Selecting Auto
value = 1 : Selecting 10HD