Brother BAS-761 - Page 148

147
Chapter 5 Practical programming examples
Programmer
23. Select with , then press .
It is set to ON.
24. Press .
25. Input the number of stitches to proceed the
needle to point M, then press .
5 is input in the example. The needle moves 5 stitches ahead.
26. Press
ESCESC
.
27. Select with , then press .
28. Input the stitch length of needle tacking, then
press .
0.5 mm is input in the example.
Input 005 to make the stitch length to 0.5 mm.
29. Move the needle with . Press when
the needle point is at point N of the pattern.
30. Press
ESCESC
twice.
31. Select with , then press .
32. Input the stitch length, then press .
3.0 mm is input in the example.
Input 030 to make the stitch length to 3.0 mm.