NUM (Numeric parameter setting mode)
No. Parameter Possible setting range
001 Not used -
002 RTN transmission condition X 1 to 99 %
003 RTN transmission condition n 2 to 99 times
004 RTN transmission condition m 1 to 99 lines
005 NCC pause time (before ID code) 1 to 60 sec
006 NCC pause time (after ID code) 1 to 60 sec
007 Not used -
008 Waiting time after dialing in STORED_DIAL_MODE 0 to 65 sec
009 Not used -
010 T.30 T0 timer 0 to 9,999
(55 sec in principle: 5,500)
011 T.30 T1 timer (for reception) 0 to 9,999
(France: 3,500, Others: 3,000)
012 The maximum number of received lines 0 to 65,535 lines
(Unlimited in the case of 0)
013 T.30 EOL timer 500 to 3,000
(Default 13 sec: 1,300)
014 Not used -
015 Threshold between hooking and on-hook 0 to 999
016 Time until a primary response is obtained when switch-
ing FAX/TEL
0 to 9
017 Pseudo RBT cadence ON time 0 to 999
018 Pseudo RBT cadence OFF time (short) 0 to 999
019 Pseudo RBT cadence OFF time (long) 0 to 999
020 Pseudo RBT cadence ON time 0 to 999
021 Pseudo CI cadence OFF time (short) 0 to 999
022 Pseudo CI cadence OFF time (long) 0 to 999
023 Not used -
024 Not used -
025 CNG monitor duration while the answering device is ac-
tivated
0 to 999
026 Not used -
027 Not used -
028 Not used -
029 Pseudo CI DUTY setting (setting can be made with
SPL71100 in special management mode.)
1 to 99
030 Not used -
031 Not used -
032 Not used -
033 Not used -
034 Not used -
035 Not used -
036 Not used -
037 Not used -
038 Not used -
039 Not used -
040 Not used -
041 Not used -
042 Not used -
043 Not used -
044 Not used -
045 Not used -
046 Not used -
8. Service Mode
269
To Next Page
Loading...
