■ AUTO RX
Numeric value parameter
Parameter No. Function Setting range
001 CI ON Time 0 to 9,999 (x10 msec)
002 CI LONG ON time 0 to 9,999 (x10 msec)
003 CI OFF time 0 to 9,999 (x10 msec)
004 CI LONG OFF time 0 to 9,999 (x10 msec)
005 CI MAX ON time 0 to 9,999 (x10 msec)
006 CI WAIT time 0 to 9,999 (x10 msec)
007 CI frequency 0 to 9,999 cycle
008 CI frequency lower limit 0 to 9,999 Hz
009 CI frequency upper limit 0 to 9,999 Hz
■ CNGDTCT (CNG DETECT)
Numeric value parameter
Parameter No. Setting description Setting range
001 At F/T switching CNG MIN ON time 0 to 9,999 (x10 msec)
002 CNG MAX ON time 0 to 9,999 (x10 msec)
003 Not used -
004 Not used -
005 Not used -
006 - -
007 At direct connection to an-
swering machine
CNG MIN ON time 0 to 9,999 (x10 msec)
008 CNG MAX ON time 0 to 9,999 (x10 msec)
009 Tolerable time of instantaneous inter-
ruption
0 to 9,999 (x10 msec)
010 Not used -
011 Number of detection 0 to 9,999 times
012 Hit ratio 0 to 9,999 %
■ SPECIALB
Not used
■ SPECIALN
Not used
■ RKEY
Numeric value parameter
Parameter No. Function Setting range
001 Connection time of flash 0 to 9,999 (x10 msec)
002 Connection time of grounding wire 0 to 9,999 (x10 msec)
003 Not used -
■ PBXDIALT (PBX DIAL TONE)
Not used
■ PBXBUSYT (PBX BUSY TONE)
Not used
8. Service Mode
273
To Next Page
Loading...
