Control Panel
Setting Item Description, Instructions
Auto(OtherPaper) Specify this mode with paper not in the Paper
Reference Guide .
The printer prints and reads a test pattern for
automatic adjustment of the feed amount. Note that
this function takes more time and consumes more ink
than Auto(GenuinePpr) .
( → P .614)
Adj.
Quality
Manual Use this mode with highly transparent media
or other paper for which Auto(GenuinePpr) or
Auto(OtherPaper) cannot be used.
Print a test pattern for adjustment of the feed amount
based on the type of paper .
( → P .616)
A:HighAdjust-
ment
Print
B:
Standard/
Draft
Print a test pattern for particular types of paper to
compensate for paper stretching or shrinkage, after
which you enter the amount of adjustment.
( → P .619)
A:High
Feed
Priority
Adjust
Length
Change
Settings
B:
Standard/
Draft
Displayed when you have selected Feed Priority >
Adj. Priority > Print Length .
Adjustment relative to the amount of stretching or
shrinkage of the current paper .
Enter either the adjustment results from
AdjustmentPrint or the discrepancy that you
measured (as a percentage).
For paper that tends to stretch, increase the feed
amount by choosing a higher adjustment value. For
paper that tends to shrink, decrease the feed amount
by choosing a lower adjustment value.
Adjust
Printer
Adj. Fine Feed Displayed when you have selected Feed Priority
> Adj. Priority > Automatic or Print Quality .
Fine-tune the feed amount manually during printing.
( → P .618)
Head Cleaning Clean the Printhead . ( → P .632)
Choose Head Cleaning A if printing is faint, oddly
colored, or contains foreign substances.
Choose Head Cleaning B if no ink is printed at all, or
if printing is not improved by Head Cleaning A .
Nozzle Check Print a test pattern to check the nozzles.
Replace P .head When replacing the Printhead , choose Y es and follow
the instructions on the screen.
( → P .633)
Not displayed during a warning message that the
remaining Maintenance Cartridge capacity is low .
Repl. maint cart When replacing the Maintenance Cartridge , choose
Y es and follow the instructions on the screen.
( → P .639)
Mainte-
nance
Head Info Indicates information about the printhead.
GL2 Replot Print the previous GL2 print job again.
Printer Parts 53
To Next Page
Loading...
Need help?
General
Weight and Dimensions
