● You can press ( ) to continue printing. However, 2-sided printing data is printed on two
sheets in 1-sided printing mode.
Cannot print with the specied resolution.
The data is too complicated to print.
● You can press
( ) to continue printing. However, the print quality is reduced.
Cannot print. Reg. Table is full.
The upper limit on the number of binders or documents in one print data item has been exceeded.
● The maximum number of binders and documents is 2 and 5, respectively, per print data item. Correct the
data, and print the le again.
● When you press ( ), the print job is canceled.
Cannot read PDF data.
An abnormality has occurred during PDF data read.
● Use the PDF data in the format supported by the machine.
● The machine supports the PDF version 1.7.
● To remove the error message, perform a soft reset to cancel the print job. Soft Reset(P. 498)
Cannot receive PDF data. Set the receivable size.
Free space is insucient to perform Direct Print for the PDF le.
● Optimize the PDF le to reduce its size or retry printing after dividing the le.
● Install the SD card, and then resend the data to the machine.
Installing an SD Card(P. 633)
● Send the data from the USB memory device to the machine.
Printing from USB Memory (USB Direct Print)(P. 118)
● When you press ( ), the print job is canceled.
Cannot start printing because job is restricted.
Normal printing has been attempted while the printing operations are restricted.
● Only Stored Job Print is available while the printing operations are restricted. Print the le again with the
settings to store data on the SD card.
Troubleshooting
523
To Next Page
Loading...
