Setting Page
111
It is necessary to set presets beforehand with [Control for Admin] > [Preset/Initial Setting] > [Preset Setting] (P. 170).
[Video Record]
Select whether to record video depending on the timer event.
If you select [Enable] and a timer event is triggered, video will be transmitted to the recording destination specified in
[Video Record Action] (P. 96).
[E-mail Notification]
When [24-Hour Continuous Setting] is set to [Disable], select whether to send an e-mail notification depending on the timer
event.
If [Enable] is selected, e-mail notification is performed when a timer event is triggered.
To use e-mail notification, you must set [Video Record] > [E-mail Notification] (P. 102) beforehand.
[External Device Output]
When [24-Hour Continuous Setting] is set to [Disable], set whether external device output (1 or 2) is active or inactive when
a timer event is triggered.
[Repeat Interval] is not supported.
[Switch Day/Night]
When [24-Hour Continuous Setting] is set to [Disable], select the Day/Night Mode switching behavior when a timer event is
triggered. This can only be set with [Timer 1].
Select [Switch to Day Mode] to switch to Day Mode at the start time, and Night Mode at the end time.
Select [Switch to Night Mode] to switch to Night Mode at the start time, and Day Mode at the end time.
[Repeat Interval] is not supported.
When control privileges are held by applications like Admin Viewer, and the camera angle has moved as a result of [Start Time Present],
camera control is released.
• If you set [Start Time] and [End Time] and select a preset with [Start Time Preset], the Day/Night setting in [Control for Admin] >
[Preset/Initial Setting] > [Preset Setting] > [Preset Registration] tab > [Advanced Preset Settings] > [Day/Night] (P. 174) is given
priority. Therefore, even if you set [Switch Day/Night] to [Switch to Day Mode] or [Switch to Night Mode], the [Switch Day/Night] setting
will be disabled if the opposite setting has been configured in [Control for Admin] > [Advanced Preset Settings].
• When [Day/Night] in the Control for Admin is set to [Auto] (P. 165), [Switch Day/Night] will not happen when a timer event is triggered.
• If the [Day/Night Mode Switching] settings switch Day/Night Mode while the user has camera control privileges, camera control will be
released.
To Next Page
Loading...
