OPERATING INSTRUCTIONS
117
RIGHT PAGE
Bur 6-34090EUR
RIDE CONTROL
Ride Control is a feature that increases the ride comfort of the Wheel
Loader over all types of terrain with either an empty or loaded bucket.
Ride Control will reduce Fore and Aft pitching motion during travel to
allow faster speeds in load and carry applications for increased
productivity and operator comfort. It will also reduce shock loads to
the Wheel Loader for reduced tire flex, structural fatigue and
vibration, resulting in longer component life and reduced costs.
Push on the symbol of the function switch for the ON position. Pull back on the
Loader Lift Control Lever to raise the lift arms until the Green light in the Ride
Control Switch intensifies. Ride Control is OFF when key switch is OFF. Ride
Control Must be reset once the engine is started again.
Ride Control can be left ON at all times, whether loading or roading.
To turn Ride Control OFF, push on the bottom of function switch for the OFF
position.
NOTE: Ride Control should be OFF when the bucket is used in fine grading
operation or when precision placement of a load suspended from the bucket or
other attachment is required.
BUCKET LEVEL INDICATOR
The bottom of the bucket is parallel
with the ground when the mark on the
bucket linkage is even with the mark on
the cylinder rod eye.
B4065588T
BC00B094
To Next Page
Loading...
Need help?
General
