Case 921C - WHEELS AND TIRES SAFETY

SAFETY/DECALS/HAND SIGNALS
15
RIGHT PAGE
Bur 6-34090EUR
● A fire can cause injury or death.
Always have a fire extinguisher near
or on the machine. Make sure the
fire extinguisher
is serviced according to the
manufacturers instructions.
● Remove all trash or debris from the
machine. Make sure that oily rags or
other flammable materials are not
stored on the machine.
● Check for fuel, oil, and hydraulic fluid
leaks. Replace worn or damaged
hoses or lines. After repairs are
made, clean the machine before you
operate.
● Starting fluid (ether) can explode and
can cause injury or death. Do not
breathe starting fluid vapors. Wear
face protection when you remove or
install a starting fluid container. Use
starting fluid according to the
instructions in this manual. See Cold
Weather Starting in this manual.
● Keep the starting fluid (ether)
container out of the reach of
children.
● Before you discard an empty starting
fluid (ether) container, use rubber
gloves and push in on the valve in
the end of the container to remove
any pressure. Do not make a hole in
the container and do not put the
container in a fire.
● Do not store starting fluid (ether)
containers in the operators area.
● If you weld, grind, or use a cutting
torch on this machine, always
remove the starting fluid (ether)
container from the machine. Use
compressed air to remove any ether
fumes from the area.
WHEELS AND TIRES SAFETY
SB134
84-113
WARNING: DO NOT weld to wheel or rim when a tire is installed. Welding
will cause an explosive air/gas mixture that will be ignited with high
temperatures. This can happen to tires inflated or deflated. Removing air
or breaking bead is not adequate. Tire MUST be completely removed from
the rim prior to welding.
WARNING: Explosive separation of the tire and/or rim parts can cause
injury or death. When tire service is necessary, have a qualified tire
mechanic service the tire.
Copyright ©