INSTRUMENTS/CONTROLS
95
RIGHT PAGE
Bur 6-34090EUR
SEAT BELT
RD97F225
1. Pull belt from holder. Fasten the
belt end into the right-hand buckle.
NOTE: Make sure the belt end and
buckle are securely fastened. Do not
pull out the right-hand buckle.
RD97F225
2. To release the seat belt, push the
red button on the buckle.
M437
Inspection and Care
1. Keep sharp edges and items that can cause damage, away from the belts.
2. From time to time, check belts, buckles, retractors, tethers, slack take-up
system and mounting bolts for damage.
3. Replace all parts that have damage or wear.
4. Replace belts that have cuts that can make the belt weak.
5. Check that bolts are tight on the seat bracket or mounting.
6. If belt is attached to seat make sure seat or seat brackets are mounted
securely.
7. Keep seat belts clean and dry.
8. Clean belts only with a soap solution and warm water.
9. Do not use bleach or dye on the belts because this can make the belts weak.
WARNING: Securely fasten your seat belt. Your machine is equipped
with a ROPS cab, ROPS canopy or ROPS frame for your protection. The
seat belt can help insure your safety if it is used and maintained. Never
wear a seat belt loosely or with slack in the belt system. Never wear the
belt in a twisted condition or pinched between the seat structural members.
To Next Page
Loading...
