Case 921C - Stopping the Engine and Parking the Machine

OPERATING INSTRUCTIONS
101
RIGHT PAGE
Bur 6-34090EUR
STOPPING THE ENGINE AND PARKING THE
MACHINE
SA038
1. Before you leave the machine,
make sure the machine is parked
on level ground. The machine must
be on level ground before you do
scheduled maintenance.
IMPORTANT: If you must temporarily
park the machine on a hillside, put the
front of the machine toward the bottom
of the hill. Make sure the machine is
behind an object that will not move.
2. Lower the loader to the ground.
3. Shift the transmission direction
control to NEUTRAL and apply the
parking brake.
4. Run the engine at idle speed for
three to five minutes to decrease
the temperature of the engine and
turbocharger.
5. Turn the key switch to the OFF
position and remove the key.
6. If your machine has a cab, lock the
cab door.
7. Turn the master disconnect switch
to the OFF position.
WARNING: Jumping on or off the machine can cause an injury. Always
face the machine, use the hand rails and steps, and get on or off the
machine slowly.
Copyright ©