LUBRICATION/FILTERS/FLUIDS
155
RIGHT PAGE
Bur 6-34090EUR
BD02B057
10. Fill the turbocharger oil lines with
oil.
A. Disconnect the wire (Shown)
from the injection pump
solenoid. This will prevent the
engine from starting.
B. Turn the key switch to the
START and actuate the starter
for 10 to 30 seconds.
C. Connect the wire to the injection
pump solenoid.
11. Start the engine and run at idle
speed. Check the engine oil filter
for leaks. After two minutes, stop
the engine, wait for 2 or 3 minutes,
and check the engine oil level with
the dipstick.
12. Close the engine access doors.
Systemgard Lubrication
Analysis Program
The normal engine oil change interval
is every 500 hours of operation or once
a year whichever occurs first.
Operating conditions, quality of the
engine oil and sulphur content of the
fuel can change this interval. It is
recommended to use the Systemgard
Lubrication Analysis Program. See
your dealer.
NOTE: Reduce oil and filter change
intervals to 250 hours if Case No. 1
Engine Oil is not used. See Engine
Service Specification in this manual.
CM107
CM115
WARNING: Never drain oil or remove oil filter while engine is running.
WARNING: Replace all covers or guards after servicing or cleaning the
machine. NEVER operate the machine with covers or guards removed.
To Next Page
Loading...
