MAINTENANCE/ADJUSTMENT
196
LEFT PAGE
Bur 6-34090EUR
5. Turn the adjustment screw (2) in or
out as required to adjust the
declutch point. Turning the
adjustment screw clockwise
increases the brake force at the
declutch. Turning the adjustment
screw counterclockwise decreases
the brake force at the declutch.
NOTE: The declutch is set the at the
factory at approximately 30 percent of
full brake system pressure.
Do not
increase this setting more that 1 turn
clockwise (approximately +325 psi)
Do
not
reduce this setting more than 1/2
turn counterclockwise (approximately -
75 psi).
6. Install the plug (1) in the base of
the left hand brake pedal/valve
assembly.
7. If the declutch is not operating
properly see the Service Manual or
your Case Dealer
To Next Page
Loading...
