MACHINE STORAGE
214
LEFT PAGE
Bur 6-34090EUR
Removal from Storage
Do not start the engine until steps 1
through 10 have been done.
1. Change the fuel filter.
2. Put coolant in the engine cooling
system.
3. Check the condition of the drive
belts. Replace if required.
4. Check the engine oil level.
5. Check the hydraulic oil level.
6. Check the transmission oil level.
7. Check the oil level of both axles.
8. Lubricate the machine at all grease
fittings.
9. Use petroleum base solvent and
remove the Case Rust and
Corrosion Preventive from the
hydraulic cylinder rods.
10. See Battery Service in this manual
and install the batteries.
11. Fill the fuel tank.
12. Prime the turbocharger with clean
engine oil. See your Service
Manual or your dealer.
13. Start the engine. It is important that
you use the Starting the Engine
procedure in this manual for
priming the turbocharger lines with
oil.
To Next Page
Loading...
