Chroma 63800 Series - Revision History

ix
Revision History
The following lists the additions, deletions and modifications in this manual at each revision.
Date
Version
Revised Sections
Feb. 2009
1.0
Complete this manual
Apr. 2009
1.1
Modify the fuse spec. of AC Input in the section of “Specifications”.
Oct. 2009
1.2
Add the following sections:
- the section of “Three Phases Parallel Setting”
- the section of “Parallel Subsystem”
- the section of “PHASE Subsystem”
Modify the following sections:
- “Constant Power Mode” and “DAM Accuracy (>70Hz)” in the
section of “Specifications”
- the displayed menus in the section of “Local Operation”
- the displayed menus in the section of “BOTH”
- the displayed menus in the section of “CC Mode”
- the displayed menu in the section of “
Setting Timing Mode Values
for Transfer Time”
- the displayed menu in the section of “DC Load Simulation”
- the displayed menu in the section of “Short Circuit On/Off”
- the descriptions in the section of “Parallel Setting”
- the descriptions in the section of “Current Subsystem”
- the descriptions in the section of “Power Subsystem”
- the descriptions in the section of “Resistance Subsystem”
Mar. 2011
1.3
Add the chapter of “Verification”.
Dec. 2011
1.4
Add the description in the following sections:
- Note in the section of “The Front Panel”.
- Notices in the sections of “AC Load Simulation”, “DC Load
Simulation” and “DC Load Simulation -- Constant Voltage Mode”.
- Using limit of DC constant voltage mode.
- the section of “Transient Over Pressure Protection”.
Modify the following sections:
- the descriptions in the sections of “Inspection”, “Ip(max) Setting
and Automatic Bandwidth Adjustment (ABA) Mode” and “Parallel
Setting”.
Jul. 2012
1.5
Modify “CE Declaration”.
Nov. 2012
1.6
Add the section of “Power Fail (PWRFAIL)”.
Modify the following sections:
- the descriptions in the section of “Specifications”.
- the Notice content in the section of “Ip(max) Setting and
Automatic Bandwidth Adjustment (ABA) Mode”.
- Figure 3-18 in the section of “Parallel Setting”.
- Figure 3-19 and 3-20 in the section of “Three Phases Parallel
Setting”.
- the description of table in the section of “LOAD Subsystem”.
- command description of “[LOAD:]RESistance:LIMit?” in the