Chroma 63800 Series User Manual

Remote Operation
8-5
8.6 SCPI Command Reference
8.6.1 Common Command Dictionary
Common commands begin with a “ * ” , and consist of three letters and/or one “ ? ” (query).
Common commands and queries are listed alphabetically.
*CLS Clear status
Description: This command clears the following registers
1. Standard Event Status register
2. Questionable Status Event
3. Standard Status Byte
Setting Syntax : *CLS
Setting Parameter : none
Query Syntax : none
Response Parameter: none
*ESE<n> Standard event status enabled
Description: This command programs the Standard Event Status Enable Register bits. If one
or more of the enable events of the Standard Event Status is set, the ESB of Status Byte
Register is set too.
Bit Configuration of Standard Event Status Enabled Register
Bit Position
7
6
5
4
3
2
1
0
Bit Name
- - -
- - -
CME
EXE
DDE
QYE
- - -
OPC
CME = Command error enable DDE = Device-dependent error
EXE = Execution error
enable OPC = Operation complete enable
QYE = Query error enable
Setting Syntax : *ESE
Setting Parameter : <NR1>, 0 ~ 255
Query Syntax : *ESE?
Response Parameter: <NR1>, 0 ~ 255
*ESR? Return standard event status register
Description: The query reads the Standard Event Status Register. Reading the Standard
Event Status Register clears it.
Setting Syntax : none
Setting Parameter : none
Query Syntax : *ESR?
Response Parameter: <NR1>, 0 ~ 255
*IDN? Return the AC Load identification string
Description: This Command queries manufacturer’s name, model name, serial number and
firmware version.
Setting Syntax : none

Chroma 63800 Series Specifications

General

Brand	Chroma
Model	63800 Series
Category	Test Equipment
Language	English