A MACHINE SET UP
A - 24
OPERATOR’SMANUAL PRO SERIES
YELLOW, MAGENTA, CYAN COLOUR INTENSITY
(0...2, 70...130) (Y:100, M.100, C:100)
Intensity for the single chromatic components.
You can correct these parameters to make the print
colouring as similar as possible to the screen
reproduction and to exalt one component compared to
another.
Press 0, 1 or 2 to select the colour to modify (yellow,
magenta and cyan respectively). Press ENTER and
modify the selected parameter.
OVERLAY INTENSITY
(200...500)
(320)
Overlay Intensity.
COLOR GRADIENT
(0...90)
(30)
Colour Pre-heating correction gradient along the card.
Defines the percentage factor for reducing the colour
printing preheating to account for the natural increase in
the temperature of the head during printing. This
parameter can be adjusted using CardTest 46, ensuring
that the monochromatic colour bands have a constant
intensity from the start to the end of the card.
FAST EJECT ENABLE
(YES/NO) (NO)
Enabling simultaneous card infeed and outfeed,
disabling the outfeed card jamming control.
This is set by the user when he prefers speed to a more
effective control of the card; this prevents having 2
cards for thermographic printing if a card which should
have been fed out is jammed.
FAST UPLOAD ENABLE
(YES/NO) (NO)
With this modality the thermo unit provide the download
of the data during the loading of the card into the
cleaner unit with consequent increase of the printing
fastness. Active only where cleaner unit is present
(T1000-T2000). Refer to the software manual to see the
necessary settings.
To Next Page
Loading...
