Cisco 300 Series Administration Guide

Security: IPV6 First Hop Security
Default Settings and Configuration
424 Cisco Small Business 200, 300 and 500 Series Managed Switch Administration Guide (Internal Version)
20
STEP 3 If required, either configure a user-defined policy or add rules to the default
policies for the feature.
STEP 4 Attach the policy to a VLAN, port or LAG using either the Policy Attachment
(VLAN) or Policy Attachment (Port) pages.
Neighbor Binding Work Flow
STEP 1 In the Neighbor Bindings Settings page, enter the list of VLANs on which this
feature is enabled.
STEP 2 In this same page, set the global configuration values that are used if no values are
set in a policy.
STEP 3 If required, either configure a user-defined policy or add rules the default policies
for the feature.
STEP 4 Add any manual entries required in the Neighbor Binding Table page
STEP 5 Attach the policy to a VLAN, port or LAG using either the Policy Attachment
(VLAN) or Policy Attachment (Port) pages.
Default Settings and Configuration
If IPv6 First Hop Security is enabled on a VLAN, the switch traps the following
messages by default:
• Router Advertisement (RA) messages
• Router Solicitation (RS) messages
• Neighbor Advertisement (NA) messages
• Neighbor Solicitation (NS) messages
• ICMPv6 Redirect messages
• Certification Path Advertisement (CPA) messages
• Certification Path Solicitation (CPS) message
• DHCPv6 messages
The FHS features are disabled by default.

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48