Cisco 7962G Administration Guide

4-27
Cisco Unified IP Phone Administration Guide for Cisco Unified Communications Manager 7.1
OL-18913-01
Chapter 4 Configuring Settings on the Cisco Unified IP Phone
Device Configuration Menu
Recording Tone Local
Vo l u m e
Indicates the loudness setting for the beep tone
that is received by the party whose phone has the
Recording Tone option enabled.
This setting applies for each listening device
(handset, speakerphone, headset).
Range: 0 percent (no tone) to 100 percent (same
level as current volume setting on the phone).
Default: 100
See also: Recording Tone
From Cisco Unified Communications Manager
Administration, choose Device > Phone > Phone
Configuration.
Recording Tone
Remote Volume
Indicates the loudness setting for the beep tone
that the remote party receives. The remote party
is the party who is on a call with the party whose
phone has the Recording Tone option enabled.
Range: 0 percent to 100 percent. (0 percent is
-66 dBM and 100 percent is -3 dBM.)
Default: 84 percent (-10dBM)
See also: Recording Tone
From Cisco Unified Communications Manager
Administration, choose Device > Phone > Phone
Configuration.
Recording Tone
Duration
Indicates the length of time in milliseconds for
which the beep tone plays.
If the value you configure here is less than one
third the interval, then this value overrides the
default provided by the Network Locale.
Range: 0 to 3000
Note For some Network Locales that use a
complex cadence, this setting applies
only to the first beep tone.
See also: Recording Tone
From Cisco Unified Communications Manager
Administration, choose Device > Phone > Phone
Configuration.
Wideband Handset Indicates whether wideband is enabled or
disabled for the handset.
Default: “Use Phone Default” on Cisco Unified
Communications Manager Administration.
(This default means that the phone will be
enabled for a wideband handset only if the
phone was shipped with a wideband handset.)
• If Wideband Handset UI Control is enabled,
you or the user can choose
> User Preferences >
Audio Preferences > Wideband Handset.
• If Wideband Handset UI Control is disabled,
use Cisco Unified Communications Manager
Administration and choose Device > Phone >
Phone Configuration to set this value.
Note If you allowed this option to be user
controllable (in the Wideband Handset UI
Control option), the user-configured value
takes precedence.
Table 4-15 Media Configuration Menu Options (continued)
Option Description To Change

Cisco 7962G Specifications

General

Mounting	Desk/Wall
Handset type	Wired handset
Product type	IP Phone
Case material	ABS
Product color	Black, Grey
Wall mountable	Yes
Bluetooth	No
Security algorithms	128-bit AES, 802.1x RADIUS
Networking standards	IEEE 802.1Q, IEEE 802.1p, IEEE 802.1x, IEEE 802.3af
Ethernet LAN data rates	10, 100 Mbit/s
Ethernet LAN interface type	Fast Ethernet
Ethernet LAN (RJ-45) ports	2
Voice codecs	G.711, G.711a, G.722, G.729A, G.729ab, iLBC
Volume control	Digital
Display diagonal	5 \
Display resolution	320 x 222 pixels
Display number of colors	Monochrome
Caller ID	-
Lines quantity	- lines
Phonebook capacity	- entries
Storage temperature (T-T)	-10 - 60 °C
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	10 - 95 %
Number of handles included	1 pc(s)

Weight and Dimensions

Depth	203.2 mm
Width	266.7 mm
Height	152.4 mm
Weight	1600 g