EasyManuals Logo

Cisco 7962G Administration Guide

Cisco 7962G
235 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #103 background imageLoading...
Page #103 background image
4-29
Cisco Unified IP Phone Administration Guide for Cisco Unified Communications Manager 7.1
OL-18913-01
Chapter 4 Configuring Settings on the Cisco Unified IP Phone
Device Configuration Menu
Ethernet Configuration Menu
The Ethernet Configuration menu includes the options that are described in Table 4-16.
Security Configuration Menu
The Security Configuration menu that you display from the Device Configuration menu displays settings
that relate to security for the phone.
Note The phone also has a Security Configuration menu that you access directly from the Settings menu. For
information about the security options on that menu, see the “Security Configuration Menu” section on
page 4-37.
Table 4-17 describes the options on the Security Configuration menu.
Table 4-16 Ethernet Configuration Menu Option
Option Description To Change
Forwarding Delay Indicates whether the internal switch begins
forwarding packets between the PC port and
switched port on the phone when the phone
becomes active.
When forwarding delay is set to disabled, the
internal switch begins forwarding packets
immediately.
When forwarding delay is set to enabled, the
internal switch waits eight seconds before
forwarding packets between the PC port and
the switch port.
Default is disabled.
From Cisco Unified Communications Manager
Administration, choose Device > Phone > Phone
Configuration.
Span to PC Port Indicates whether the phone will forward packets
transmitted and received on the network port to the
access port.
Enable this option if an application that requires
monitoring of the phone’s traffic is being run on
the access port. These applications include
monitoring and recording applications (common
in call center environments) and network packet
capture tools that are used for diagnostic purposes.
From Cisco Unified Communications Manager
Administration, choose Device > Phone > Phone
Configuration.
Table 4-17 Security Configuration Menu Options
Option Description To Change
PC Port Disabled Indicates whether the access port on the phone is
enabled (Yes) or disabled (No).
Must be set to enabled for video support on the
phone
From Cisco Unified Communications Manager
Administration, choose Device > Phone > Phone
Configuration.

Table of Contents

Other manuals for Cisco 7962G

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco 7962G and is the answer not in the manual?

Cisco 7962G Specifications

General IconGeneral
MountingDesk/Wall
Handset typeWired handset
Product typeIP Phone
Case materialABS
Product colorBlack, Grey
Wall mountableYes
BluetoothNo
Security algorithms128-bit AES, 802.1x RADIUS
Networking standardsIEEE 802.1Q, IEEE 802.1p, IEEE 802.1x, IEEE 802.3af
Ethernet LAN data rates10, 100 Mbit/s
Ethernet LAN interface typeFast Ethernet
Ethernet LAN (RJ-45) ports2
Voice codecsG.711, G.711a, G.722, G.729A, G.729ab, iLBC
Volume controlDigital
Display diagonal5 \
Display resolution320 x 222 pixels
Display number of colorsMonochrome
Caller ID-
Lines quantity- lines
Phonebook capacity- entries
Storage temperature (T-T)-10 - 60 °C
Operating temperature (T-T)0 - 40 °C
Operating relative humidity (H-H)10 - 95 %
Number of handles included1 pc(s)
Weight and Dimensions IconWeight and Dimensions
Depth203.2 mm
Width266.7 mm
Height152.4 mm
Weight1600 g

Related product manuals