Cisco 7962G Administration Guide

4-4
Cisco Unified IP Phone Administration Guide for Cisco Unified Communications Manager 7.1
OL-18913-01
Chapter 4 Configuring Settings on the Cisco Unified IP Phone
Overview of Options Configurable from a Phone
Related Topics
• Displaying a Configuration Menu, page 4-2
• Unlocking and Locking Options, page 4-2
• Overview of Options Configurable from a Phone, page 4-4
• Network Configuration Menu, page 4-5
• Device Configuration Menu, page 4-16
• Security Configuration Menu, page 4-37
Overview of Options Configurable from a Phone
The settings that you can change on a phone fall into several categories, as shown in Table 4-1. For a
detailed explanation of each setting and instructions for changing them, see the “Network Configuration
Menu” section on page 4-5.
Note There are several options on the Network Configuration menu and on the Device Configuration Menu
that are for display only or that you can configure from Cisco Unified Communications Manager. These
options are also described in this chapter.
Table 4-1 Settings Configurable from the Phone
Category Description Network Configuration Menu Option
General Network Settings
VLAN settings Admin. VLAN ID allows you to change the
administrative VLAN used by the phone. PC VLAN
allows the phone to interoperate with third-party switches
that do not support a voice VLAN.
Admin. VLAN ID
PC VLAN
Port settings Allow you to set the speed and duplex of the network and
access ports.
SW Port Configuration
PC Port Configuration
IPv4 Network Settings
DHCP settings Dynamic Host Configuration Protocol (DHCP)
automatically assigns IP address to devices when you
connect them to the network. Cisco Unified IP Phones
enable DHCP by default.
DHCP
DHCP Address Released
IP settings If you do not use DHCP in your network, you can make
IP settings manually.
Domain Name
IP Address
Subnet Mask
Default Router 1-5
DNS Server 1-5
TFTP settings for TFTP
IPv4 servers
If you do not use DHCP to direct the phone to a TFTP
server, you must manually assign a TFTP server. You can
also assign an alternative TFTP server to use instead of
the one assigned by DHCP.
Alternate TFTP
TFTP Server 1
TFTP Server 2
IPv6 Network Settings

Cisco 7962G Specifications

General

Mounting	Desk/Wall
Handset type	Wired handset
Product type	IP Phone
Case material	ABS
Product color	Black, Grey
Wall mountable	Yes
Bluetooth	No
Security algorithms	128-bit AES, 802.1x RADIUS
Networking standards	IEEE 802.1Q, IEEE 802.1p, IEEE 802.1x, IEEE 802.3af
Ethernet LAN data rates	10, 100 Mbit/s
Ethernet LAN interface type	Fast Ethernet
Ethernet LAN (RJ-45) ports	2
Voice codecs	G.711, G.711a, G.722, G.729A, G.729ab, iLBC
Volume control	Digital
Display diagonal	5 \
Display resolution	320 x 222 pixels
Display number of colors	Monochrome
Caller ID	-
Lines quantity	- lines
Phonebook capacity	- entries
Storage temperature (T-T)	-10 - 60 °C
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	10 - 95 %
Number of handles included	1 pc(s)

Weight and Dimensions

Depth	203.2 mm
Width	266.7 mm
Height	152.4 mm
Weight	1600 g