Cisco 7962G Administration Guide

4-30
Cisco Unified IP Phone Administration Guide for Cisco Unified Communications Manager 7.1
OL-18913-01
Chapter 4 Configuring Settings on the Cisco Unified IP Phone
Device Configuration Menu
QoS Configuration Menu
The QoS Configuration menu displays information that relates to quality of service (QoS) for the phone.
Table 4-18 describes the options on this menu.
GARP Enabled Indicates whether the phone learns MAC
addresses from Gratuitous Address Resolution
Protocol (ARP) responses. Disabling the phone’s
ability to accept Gratuitous ARP will prevent
applications that use this mechanism to monitor
and record voice streams from working. If voice
monitoring is not desired, set this option to No
(disabled).
From Cisco Unified Communications Manager
Administration, choose Device > Phone > Phone
Configuration.
Vo i c e V L A N
Enabled
Indicates whether the phone allows a device
attached to the access port to access the Voice
VLAN. Setting this option to No (disabled)
prevents the attached PC from sending and
receiving data on the Voice VLAN. This setting
also prevents the PC from receiving data sent and
received by the phone. Set this setting to Yes
(enabled) if an application that requires
monitoring of the phone’s traffic is running on the
PC. These applications include monitoring and
recording applications and network monitoring
software.
From Cisco Unified Communications Manager
Administration, choose Device > Phone > Phone
Configuration.
Web Access
Enabled
Indicates whether web access is enabled (Yes) or
disabled (No) for the phone.
From Cisco Unified Communications Manager
Administration, choose Device > Phone > Phone
Configuration.
Security Mode Displays the security mode that is set for the
phone.
Use Cisco Unified Communications Manager
Administration to modify.
Logging Display For use by the Cisco Technical Assistance Center (TAC), if necessary.
Table 4-17 Security Configuration Menu Options (continued)
Option Description To Change
Table 4-18 QoS Configuration Menu Options
Option Description To Change
DSCP for Call
Control
Differentiated Services Code Point (DSCP) IP
classification for call control signaling.
From Cisco Unified Communications Manager
Administration, choose System > Enterprise
Parameters.
DSCP for
Configuration
DSCP IP classification for any phone
configuration transfer.
From Cisco Unified Communications Manager
Administration, choose System > Enterprise
Parameters.
DSCP for Services DSCP IP classification for phone-based
services.
From Cisco Unified Communications Manager
Administration, choose System > Enterprise
Parameters.

Cisco 7962G Specifications

General

Mounting	Desk/Wall
Handset type	Wired handset
Product type	IP Phone
Case material	ABS
Product color	Black, Grey
Wall mountable	Yes
Bluetooth	No
Security algorithms	128-bit AES, 802.1x RADIUS
Networking standards	IEEE 802.1Q, IEEE 802.1p, IEEE 802.1x, IEEE 802.3af
Ethernet LAN data rates	10, 100 Mbit/s
Ethernet LAN interface type	Fast Ethernet
Ethernet LAN (RJ-45) ports	2
Voice codecs	G.711, G.711a, G.722, G.729A, G.729ab, iLBC
Volume control	Digital
Display diagonal	5 \
Display resolution	320 x 222 pixels
Display number of colors	Monochrome
Caller ID	-
Lines quantity	- lines
Phonebook capacity	- entries
Storage temperature (T-T)	-10 - 60 °C
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	10 - 95 %
Number of handles included	1 pc(s)

Weight and Dimensions

Depth	203.2 mm
Width	266.7 mm
Height	152.4 mm
Weight	1600 g