EasyManuals Logo

Cisco Catalyst 2960-XR User Manual

Cisco Catalyst 2960-XR
404 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #273 background imageLoading...
Page #273 background image
SUMMARY STEPS
1.
configure terminal
2.
aaa new-model
3.
aaa authentication dot1x {default} method1
4.
interface interface-id
5.
switchport mode access
6.
authentication violation {shutdown | restrict | protect | replace}
7.
end
DETAILED STEPS
PurposeCommand or Action
Enters the global configuration mode.configure terminal
Example:
Switch# configure terminal
Step 1
Enables AAA.aaa new-model
Example:
Switch(config)# aaa new-model
Step 2
Creates an 802.1x authentication method list.
aaa authentication dot1x {default} method1
Step 3
Example:
Switch(config)# aaa authentication dot1x
To create a default list that is used when a named list is not specified
in the authentication command, use the default keyword followed
by the method that is to be used in default situations. The default
method list is automatically applied to all ports.
default group radius
For method1, enter the group radius keywords to use the list of all
RADIUS servers for authentication.
Though other keywords are visible in the command-line help
string, only the group radius keywords are supported.
Note
Specifies the port connected to the client that is to be enabled for
IEEE 802.1x authentication, and enter interface configuration mode.
interface interface-id
Example:
Switch(config)# interface
Step 4
gigabitethernet1/0/4
Sets the port to access mode.switchport mode access
Example:
Switch(config-if)# switchport mode access
Step 5
Catalyst 2960-XR Switch Security Configuration Guide, Cisco IOS Release 15.0(2)EX1
OL-29434-01 251
Configuring IEEE 802.1x Port-Based Authentication
Configuring 802.1x Violation Modes

Table of Contents

Other manuals for Cisco Catalyst 2960-XR

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 2960-XR and is the answer not in the manual?

Cisco Catalyst 2960-XR Specifications

General IconGeneral
Stacking Bandwidth80 Gbps
Layer SupportLayer 2 and Layer 3
Jumbo Frame Support9198 bytes
RAM512 MB
Input Voltage100-240V AC
ModelCatalyst 2960-XR
Uplink Interfaces4 x 1G SFP or 2 x 10G SFP+
Downlink Interfaces24 or 48 x Gigabit Ethernet ports
Power SupplyInternal
MAC Address Table Size16, 000 entries
PoEAvailable on PoE models
Weight4.5 kg
Featuresenergy efficiency
StackingUp to 8 switches
Operating Temperature0 to 45°C

Related product manuals