Cisco Catalyst 2960-XR User Manual

CHAPTER 5
Configuring TACACS+
•
Finding Feature Information, page 37
•
Prerequisites for Controlling Switch Access with Terminal Access Controller Access Control System
Plus (TACACS+), page 37
•
Information About TACACS+, page 39
•
How to Configure TACACS+, page 43
•
Monitoring TACACS+, page 50
Finding Feature Information
Your software release may not support all the features documented in this module. For the latest feature
information and caveats, see the release notes for your platform and software release.
Use Cisco Feature Navigator to find information about platform support and Cisco software image support.
To access Cisco Feature Navigator, go to http://www.cisco.com/go/cfn. An account on Cisco.com is not
required.
Prerequisites for Controlling Switch Access with Terminal
Access Controller Access Control System Plus (TACACS+)
The following are the prerequisites for set up and configuration of switch access with Terminal Access
Controller Access Control System Plus (TACACS+) (must be performed in the order presented):
1
Configure the switches with the TACACS+ server addresses.
2
Set an authentication key.
3
Configure the key from Step 2 on the TACACS+ servers.
4
Enable AAA.
5
Create a login authentication method list.
6
Apply the list to the terminal lines.
Catalyst 2960-XR Switch Security Configuration Guide, Cisco IOS Release 15.0(2)EX1
OL-29434-01 37

Cisco Catalyst 2960-XR Specifications

General

Stacking Bandwidth	80 Gbps
Layer Support	Layer 2 and Layer 3
Jumbo Frame Support	9198 bytes
RAM	512 MB
Input Voltage	100-240V AC
Model	Catalyst 2960-XR
Uplink Interfaces	4 x 1G SFP or 2 x 10G SFP+
Downlink Interfaces	24 or 48 x Gigabit Ethernet ports
Power Supply	Internal
MAC Address Table Size	16, 000 entries
PoE	Available on PoE models
Weight	4.5 kg
Features	energy efficiency
Stacking	Up to 8 switches
Operating Temperature	0 to 45°C