Cisco Catalyst 2960-XR User Manual

Default SettingFeature
1.Maximum number of secure MAC
addresses per port
Shutdown. The port shuts down when the maximum number of secure
MAC addresses is exceeded.
Violation mode
Disabled. Aging time is 0.
Static aging is disabled.
Type is absolute.
Port security aging
Port Security Configuration Guidelines
•
Port security can only be configured on static access ports or trunk ports. A secure port cannot be a
dynamic access port.
•
A secure port cannot be a destination port for Switched Port Analyzer (SPAN).
•
A secure port cannot belong to a Gigabit EtherChannel port group.
Voice VLAN is only supported on access ports and not on trunk ports, even though the
configuration is allowed.
Note
•
A secure port cannot be a private-VLAN port.
•
When you enable port security on an interface that is also configured with a voice VLAN, set the
maximum allowed secure addresses on the port to two. When the port is connected to a Cisco IP phone,
the IP phone requires one MAC address. The Cisco IP phone address is learned on the voice VLAN,
but is not learned on the access VLAN. If you connect a single PC to the Cisco IP phone, no additional
MAC addresses are required. If you connect more than one PC to the Cisco IP phone, you must configure
enough secure addresses to allow one for each PC and one for the phone.
•
When a trunk port configured with port security and assigned to an access VLAN for data traffic and to
a voice VLAN for voice traffic, entering the switchport voice and switchport priority extend interface
configuration commands has no effect.
When a connected device uses the same MAC address to request an IP address for the access VLAN
and then an IP address for the voice VLAN, only the access VLAN is assigned an IP address.
•
When you enter a maximum secure address value for an interface, and the new value is greater than the
previous value, the new value overwrites the previously configured value. If the new value is less than
the previous value and the number of configured secure addresses on the interface exceeds the new
value, the command is rejected.
•
The switch does not support port security aging of sticky secure MAC addresses.
This table summarizes port security compatibility with other port-based features.
Catalyst 2960-XR Switch Security Configuration Guide, Cisco IOS Release 15.0(2)EX1
OL-29434-01 339
Configuring Port-Based Traffic Control
Port Security Configuration Guidelines

Cisco Catalyst 2960-XR Specifications

General

Stacking Bandwidth	80 Gbps
Layer Support	Layer 2 and Layer 3
Jumbo Frame Support	9198 bytes
RAM	512 MB
Input Voltage	100-240V AC
Model	Catalyst 2960-XR
Uplink Interfaces	4 x 1G SFP or 2 x 10G SFP+
Downlink Interfaces	24 or 48 x Gigabit Ethernet ports
Power Supply	Internal
MAC Address Table Size	16, 000 entries
PoE	Available on PoE models
Weight	4.5 kg
Features	energy efficiency
Stacking	Up to 8 switches
Operating Temperature	0 to 45°C