Cisco Catalyst 2960-XR User Manual

CHAPTER 10
Configuring IPv4 ACLs
•
Finding Feature Information, page 105
•
Prerequisites for Configuring Network Security with ACLs, page 105
•
Restrictions for Configuring Network Security with ACLs, page 105
•
Information about Network Security with ACLs, page 107
•
How to Configure ACLs, page 120
•
Monitoring IPv4 ACLs, page 139
•
Configuration Examples for ACLs, page 140
Finding Feature Information
Your software release may not support all the features documented in this module. For the latest feature
information and caveats, see the release notes for your platform and software release.
Use Cisco Feature Navigator to find information about platform support and Cisco software image support.
To access Cisco Feature Navigator, go to http://www.cisco.com/go/cfn. An account on Cisco.com is not
required.
Prerequisites for Configuring Network Security with ACLs
This section lists the prerequisites for configuring network security with Access Control Lists (ACLs).
•
On switches running the LAN base feature set, VLAN maps are not supported.
Restrictions for Configuring Network Security with ACLs
General Network Security
The following are restrictions for configuring network security with ACLs:
Catalyst 2960-XR Switch Security Configuration Guide, Cisco IOS Release 15.0(2)EX1
OL-29434-01 105

Cisco Catalyst 2960-XR Specifications

General

Stacking Bandwidth	80 Gbps
Layer Support	Layer 2 and Layer 3
Jumbo Frame Support	9198 bytes
RAM	512 MB
Input Voltage	100-240V AC
Model	Catalyst 2960-XR
Uplink Interfaces	4 x 1G SFP or 2 x 10G SFP+
Downlink Interfaces	24 or 48 x Gigabit Ethernet ports
Power Supply	Internal
MAC Address Table Size	16, 000 entries
PoE	Available on PoE models
Weight	4.5 kg
Features	energy efficiency
Stacking	Up to 8 switches
Operating Temperature	0 to 45°C