CHAPTER 6
Configuring RADIUS
•
Finding Feature Information, page 51
•
Prerequisites for Controlling Switch Access with RADIUS, page 51
•
Restrictions for Controlling Switch Access with RADIUS, page 52
•
Information about RADIUS, page 53
•
How to Configure RADIUS, page 65
•
Monitoring CoA Functionality, page 79
•
Configuration Examples for Controlling Switch Access with RADIUS, page 79
Finding Feature Information
Your software release may not support all the features documented in this module. For the latest feature
information and caveats, see the release notes for your platform and software release.
Use Cisco Feature Navigator to find information about platform support and Cisco software image support.
To access Cisco Feature Navigator, go to http://www.cisco.com/go/cfn. An account on Cisco.com is not
required.
Prerequisites for Controlling Switch Access with RADIUS
This section lists the prerequisites for controlling Catalyst switch access with RADIUS.
General:
•
RADIUS and AAA must be enabled to use any of the configuration commands in this chapter.
•
RADIUS is facilitated through AAA and can be enabled only through AAA commands.
•
At a minimum, you must identify the host or hosts that run the RADIUS server software and define the
method lists for RADIUS authentication. You can optionally define method lists for RADIUS
authorization and accounting.
•
You should have access to and should configure a RADIUS server before configuring RADIUS features
on your switch.
Catalyst 2960-XR Switch Security Configuration Guide, Cisco IOS Release 15.0(2)EX1
OL-29434-01 51
To Next Page
Loading...
