Cisco Catalyst 2960-XR - Enabling MAC Move

SUMMARY STEPS
1.
configure terminal
2.
interface interface-id
3.
switchport mode access
4.
dot1x max-req count
5.
end
DETAILED STEPS
PurposeCommand or Action
Enters the global configuration mode.configure terminal
Example:
Switch# configure terminal
Step 1
Specifies the port to be configured, and enter interface
configuration mode.
interface interface-id
Example:
Switch# interface gigabitethernet2/0/1
Step 2
Sets the port to access mode only if you previously configured
the RADIUS server.
switchport mode access
Example:
Switch(config-if)# switchport mode access
Step 3
Sets the number of times that the switch restarts the
authentication process before the port changes to the
unauthorized state. The range is 0 to 10; the default is 2.
dot1x max-req count
Example:
Switch(config-if)# dot1x max-req 4
Step 4
Returns to privileged EXEC mode.end
Example:
Switch(config-if)# end
Step 5
Enabling MAC Move
MAC move allows an authenticated host to move from one port on the switch to another.
Catalyst 2960-XR Switch Security Configuration Guide, Cisco IOS Release 15.0(2)EX1
264 OL-29434-01
Configuring IEEE 802.1x Port-Based Authentication
Enabling MAC Move