Cisco Catalyst 2960-XR User Manual

PurposeCommand or Action
Verifies the ND Inspection Configuration without
exiting ND inspection configuration mode.
do show ipv6 nd inspection policy policy_name
Example:
Switch(config-nd-inspection)# do show ipv6 nd inspection
policy example_policy
Step 12
How to Attach an IPv6 Neighbor Discovery Inspection Policy to an Interface
Beginning in privileged EXEC mode, follow these steps to attach an IPv6 ND Inspection policy to an interface
or VLANs on an interface :
SUMMARY STEPS
1.
configure terminal
2.
interface Interface_type stack/module/port
3.
ipv6 nd inspection [attach-policy policy_name [ vlan {vlan_ids | add vlan_ids | except vlan_ids | none
| remove vlan_ids | all} ] | vlan [ {vlan_ids | add vlan_ids | exceptvlan_ids | none | remove vlan_ids |
all} ]
4.
do show running-config
DETAILED STEPS
PurposeCommand or Action
Enters the global configuration mode.configure terminal
Example:
Switch# configure terminal
Step 1
Specifies an interface type and identifier; enters the
interface configuration mode.
interface Interface_type stack/module/port
Example:
Switch(config)# interface gigabitethernet 1/1/4
Step 2
Attaches the Neighbor Discovery Inspection policy
to the interface or the specified VLANs on that
ipv6 nd inspection [attach-policy policy_name [ vlan {vlan_ids
| add vlan_ids | except vlan_ids | none | remove vlan_ids | all}
Step 3
interface. The default policy is attached if the
attach-policy option is not used.
] | vlan [ {vlan_ids | add vlan_ids | exceptvlan_ids | none |
remove vlan_ids | all} ]
Example:
Switch(config-if)# ipv6 nd inspection attach-policy
example_policy
or
Switch(config-if)# ipv6 nd inspection attach-policy
example_policy vlan 222,223,224
Catalyst 2960-XR Switch Security Configuration Guide, Cisco IOS Release 15.0(2)EX1
360 OL-29434-01
Configuring IPv6 First Hop Security
How to Attach an IPv6 Neighbor Discovery Inspection Policy to an Interface

Cisco Catalyst 2960-XR Specifications

General

Stacking Bandwidth	80 Gbps
Layer Support	Layer 2 and Layer 3
Jumbo Frame Support	9198 bytes
RAM	512 MB
Input Voltage	100-240V AC
Model	Catalyst 2960-XR
Uplink Interfaces	4 x 1G SFP or 2 x 10G SFP+
Downlink Interfaces	24 or 48 x Gigabit Ethernet ports
Power Supply	Internal
MAC Address Table Size	16, 000 entries
PoE	Available on PoE models
Weight	4.5 kg
Features	energy efficiency
Stacking	Up to 8 switches
Operating Temperature	0 to 45°C