Cisco Catalyst 2960-XR - Configuring a Supplicant Switch with NEAT

PurposeCommand or Action
Verifies your configuration.
show running-config interface interface-id
Example:
Switch# show running-config interface
Step 9
gigabitethernet2/0/1
(Optional) Saves your entries in the configuration
file.
copy running-config startup-config
Example:
Switch# copy running-config startup-config
Step 10
Configuring a Supplicant Switch with NEAT
Beginning in privileged EXEC mode, follow these steps to configure a switch as a supplicant:
SUMMARY STEPS
1.
configure terminal
2.
cisp enable
3.
dot1x credentials profile
4.
username suppswitch
5.
password password
6.
dot1x supplicant force-multicast
7.
interface interface-id
8.
switchport trunk encapsulation dot1q
9.
switchport mode trunk
10.
dot1x pae supplicant
11.
dot1x credentials profile-name
12.
end
13.
show running-config interface interface-id
14.
copy running-config startup-config
15.
Configuring NEAT with Auto Smartports Macros
Catalyst 2960-XR Switch Security Configuration Guide, Cisco IOS Release 15.0(2)EX1
286 OL-29434-01
Configuring IEEE 802.1x Port-Based Authentication
Configuring a Supplicant Switch with NEAT