Cisco Catalyst 2960-XR - How to Configure an Ipv6 Router Advertisement Guard Policy

PurposeCommand or Action
Confirms that the policy is attached to the specified VLANs
without exiting the configuration mode.
do show running-config
Example:
Switch#(config-if)# do show running-config
Step 4
How to Configure an IPv6 Router Advertisement Guard Policy
Beginning in privileged EXEC mode, follow these steps to configure an IPv6 Router Advertisement policy :
SUMMARY STEPS
1.
configure terminal
2.
[no]ipv6 nd raguard policy policy-name
3.
device-role {host | monitor | router | switch}
4.
hop-limit {maximum | minimum} value
5.
managed-config-flag {off | on}
6.
match {ipv6 access-list list | ra prefix-list list}
7.
other-config-flag {on | off}
8.
router-preference maximum {high | medium | low}
9.
trusted-port
10.
default {device-role | hop-limit {maximum | minimum} | managed-config-flag | match {ipv6 access-list
| ra prefix-list } | other-config-flag | router-preference maximum| trusted-port}
11.
no {device-role | hop-limit {maximum | minimum} | managed-config-flag | match {ipv6 access-list |
ra prefix-list } | other-config-flag | router-preference maximum| trusted-port}
12.
do show ipv6 nd raguard policy policy_name
DETAILED STEPS
PurposeCommand or Action
Enters the global configuration mode.configure terminal
Example:
Switch# configure terminal
Step 1
Specifies the RA Guard policy name and enters RA
Guard Policy configuration mode.
[no]ipv6 nd raguard policy policy-name
Example:
Switch(config)# ipv6 nd raguard policy example_policy
Step 2
Catalyst 2960-XR Switch Security Configuration Guide, Cisco IOS Release 15.0(2)EX1
362 OL-29434-01
Configuring IPv6 First Hop Security
How to Configure an IPv6 Router Advertisement Guard Policy