00 0293 210 2 - BA DOMINATOR 150/140/130 - 12/09 123
7 Overview of controls
7.2 Cab / Operator's platform
67083
– Observe the general warnings at the beginning of
the "Overview of controls" chapter.
All magnetic pick-ups (J) must be set to a gap of 1 ±
0.5 mm between gear wheels (Z) and the magnetic
pick-up.
When the engine is being started, the buzzer sounds
briefly until the engine oil pressure has built up.
The shaft speed-loss monitors are switched on and off
by means of a switch that is activated by the cutterbar
drive control mechanism.
23
19431
Z
J
To Next Page
Loading...
