00 0293 210 2 - BA DOMINATOR 150/140/130 - 12/09 39
3 Safety
3.1 General Information
67079
59180
3.1.12 Driving operations on slopes
• When travelling downhill with a slope of more than
7%, always shift one gear down (braking effect of
diesel engine)!
• When travelling downhill in general, never exceed
the allowed max. ground speed of 20 (25) km/h.
2419
3.1.13 Leaving the machine
• When leaving the machine, ensure that it will not
roll away (apply parking brake, wheel chocks).
Shut off the engine. Remove the ignition key and
lock the operator's cab.
• When the machine is shut down for an extended
period, turn off the battery isolating switch.
• Never leave the machine unattended as long as
the engine is still running!
• Lower the front attachments to the ground before
leaving the machine!
2420
3.1.14 Front attachments and trailers
• Support raised front attachments securely before
doing any work underneath the units.
• Take particular care when mounting front attach-
ments to the basic machine and when attaching a
trailer.
• Owing to their function, front attachments and
feeder mechanisms such as belts, rollers, chains,
worm gears, reels and the like cannot be com-
pletely protected by design measures; for this
reason, an adequate safety distance must be
maintained from these moving elements during
operation. These instructions also apply to all
other accessories operated on the machine.
• No person must ever be allowed between the
machine and the front attachment unless the park-
ing brake is applied and/or the wheels are
chocked so that the vehicle can not start to move
on its own.
• Front attachments and trailers must only be
attached to the coupling devices provided for that
purpose. Observe the maximum permissible load
capacity of the trailer hitch.
• Hitch the trailer correctly to the forage harvester.
Be alert when connecting a trailer to the forage
harvester.
• Before disconnecting a front attachment always
make sure that it is stable and securely parked.
• When attaching front attachments always make
sure that the load on the existing rear axle is suffi-
cient to maintain the forage harvester's steering
and braking capabilities.
To Next Page
Loading...
