182 00 0293 210 2 - BA DOMINATOR 150/140/130 - 12/09
10 Fieldwork settings
10.5 Cleaning unit
67086
– Adjust the sensitivity of the sensors to the different
grain sizes on switch (4).
The sensors react more / less sensitively, depending
on the pre-set grain size.
82957
10.5.3 Removing the sieves
The sieves must / can be installed / removed as a
function of the crop to be harvested. See threshing
chart, see sieve chart.
The sieves can be removed / installed independently
of one another.
The straw chopper can be shifted to the rear as far as
possible. In this installation position, the sieves can be
mounted.
See straw chopper sieves installation position.
– Observe the general warnings at the beginning of
the "Fieldwork settings" chapter.
Removing the upper sieves
– Unscrew bolts (1).
– Remove bolts (2).
– Pull out the upper sieve to the rear.
Removing the lower sieves
(machines with performance monitor)
– Unscrew bolts (1).
– Fold sensor (2) down.
17
10789
2
1
3
4
Sensitivity of sensors
Position Grain sizes
1 for lightweight grains
2 for medium-weight grains
3 for heavy grains
18
19638
1
1
2
2
19
19638
1
1
2
To Next Page
Loading...
