Claas DOMINATOR 130 - 4 Checking the Rasp Plates on the Feed Rake Conveyor

00 0293 210 2 - BA DOMINATOR 150/140/130 - 12/09 355
13 Maintenance
13.12 Feeder unit
67089
The slip clutch (1) protects the feeder chain against
overload.
– Never tighten the bolts to such an extent that the
slip clutch becomes locked and thereby fails to
function as a safety device.
– Adjust the slip torque when the slip clutch is cold.
Slip torque = 220 Nm for springs with spacer tubes
Slip torque = 430 Nm with double springs
64786
13.12.4 Checking the rasp plates on the feed
rake conveyor
– Observe the general warnings at the beginning of
the "Maintenance" chapter.
The rasp plates wear due to the front attachment
movements.
– Check wear of rasp plates.
134
19597
1
Note!
Insufficient specialist knowledge for repair and
maintenance work.
Machine damage.
– Only have authorised and qualified work-
shops carry out work on this component.
135
22082
Condition Task
Rasp plate protrude around 1 mm at the rear. - Check rasp plates in the next maintenance interval.
The rasp plates are flush with the feed rake conveyor
when installed in the first hole pattern.
- Relocate rasp plates and use second hole pattern.
The rasp plates are flush with the feed rake conveyor
when installed in the second hole pattern.
- Install new rasp plates.