Claas DOMINATOR 130 - 16 Changing the Fuel Filter CATERPILLAR C-6.6; 3056 E

00 0293 210 2 - BA DOMINATOR 150/140/130 - 12/09 289
13 Maintenance
13.5 Engine
67089
86264
13.5.16 Changing the fuel filter
CATERPILLAR C-6.6 / 3056 E
– Observe the general warnings at the beginning of
the "Maintenance" chapter.
– Observe the information provided in the operator's
manual of the engine manufacturer.
– Close the shut-off tap of the fuel system.
– Unscrew the filter (1).
– Clean the inside of the filter head.
– Apply some oil to the new seal and screw on new
filter (1) until the filter seal touches the filter head.
Tighten the filter by hand.
– Open the shut-off tap of the fuel system.
– Bleed fuel system.
– Start the diesel engine.
Let diesel engine run at min. no-load speed for
about 10 seconds.
– Check tightness of fuel filter.
Environment!
Lubricants and fuels end up in the
environment.
Environmental pollution.
– Lubricants and fuels must be collected
and stored in suitable containers and dis-
posed of in a way that is harmless to the
environment and in accordance with
existing anti-pollution regulations.
WARNING:
Soiling of fuel system.
Machine damage.
– Make sure surroundings are clean.
– Use suitable and clean tools.
– Ensure that no dirt can enter the fuel
system.
27
CATERPILLAR C-6.6
27296
28
CATERPILLAR 3056 E
29340
1
1
WARNING:
Use of unpermissible spare parts or
lubricants.
Machine damage or increased wear.
– Spare parts and lubricants must at least
comply with the technical standards
required by the manufacturer of the
implement!
– The use of genuine CLAAS spare parts
and lubricants is recommended.