Claas DOMINATOR 130 - Checking the Final Drive Oil Level DOMINATOR 130; Draining the Final Drive Oil DOMINATOR 130

00 0293 210 2 - BA DOMINATOR 150/140/130 - 12/09 311
13 Maintenance
13.6 Chassis
67089
– Unscrew bolt (1).
– Fill in new oil.
– Check oil level , top up if necessary.
– Remove dirt from bolt (1).
– Screw in bolt (1) with sealant.
– Repeat this procedure on the other side of the
machine.
86784
13.6.7 Checking the final drive oil level
DOMINATOR 130
– Park the machine on level ground.
– Observe the general warnings at the beginning of
the "Maintenance" chapter.
– Unscrew bolt (1).
The oil level must be up to the bore at bolt (1).
– Top up oil if required.
– Remove dirt from bolt (1).
– Screw in bolt (1) with sealant.
– Repeat this procedure on the other side of the
machine.
86786
13.6.8 Draining the final drive oil
DOMINATOR 130
– Park the machine on level ground.
– Observe the general warnings at the beginning of
the "Maintenance" chapter.
65
23392
1
Caution!
Machine operation with unpermitted or pol-
luted lubricants.
Machine damage.
– Ensure a clean environment.
– Use suitable and clean tools.
– Use permitted lubricants.
– Lubricants must be free of pollution.
66
Right side
23393
1