00 0293 210 2 - BA DOMINATOR 150/140/130 - 12/09 259
13 Maintenance
13.2 General Information
67089
13.2 General Information
11089
13.2.1 Front attachment
7791
13.2.2 Cleaning the engine compartment and
hazard areas
– Clean the engine area and above all the exhaust
system as well as the areas around the brakes,
gearbox and similar components thoroughly in
order to avoid fire hazards.
– When working in very dry crop and very dusty
conditions, check the spots mentioned above for
dirt accumulations more frequently and clean
them if necessary.
7466
13.2.3 Belts
– Keep all belts well-tensioned at all times.
– Belts soiled with oil can be cleaned with cleaning
lye. Do not use gasoline or similar products.
– After installing a new belt, check tension after the
first 2 to 3 working hours and adjust if
necessary.
7467
13.2.4 Variable-speed drives
– Whenever the variable-speed pulleys have been
greased, operate the pulleys a few times to
ensure even spreading of grease on sliding parts.
– Remove any accumulations of dust from between
the variable speed pulley halves to make sure the
pulleys can be run through their full speed range.
7468
13.2.5 Bolts
– Check all bolts for a tight seat and retighten if nec-
essary (especially all nuts on the chassis and on
the steering system).
1110 3
13.2.6 Lubrication
– Observe the specified oil change intervals and oil
grades in the hydraulic system and in the
gearboxes.
– Use only the specified grease for greasing the
machine.
– Before greasing, remove the dirt on the grease
nipple.
Danger!
The front attachment, reel and feeder unit may
drop uncontrolled.
Death or serious injuries!
– Apply safety locks.
– Keep a safe distance from the hazard
area.
To Next Page
Loading...
