284 00 0293 210 2 - BA DOMINATOR 150/140/130 - 12/09
13 Maintenance
13.5 Engine
67089
– Close the shut-off tap of the fuel system.
– Unscrew the filter pot (1) and remove the filter
element.
– Wash the filter element and sight glass in diesel
fuel and blow out with compressed air.
– Insert filter element and fit filter pot (1).
Make sure the seal is properly fitted!
Replace damaged seals!
– Open the shut-off tap of the fuel system.
– Bleed fuel system.
86100
13.5.12 Draining condensation at the fuel pre-
filter (standard equipment)
The fuel pre-filter is accessible after opening the right-
hand side panel.
Any water contained in the fuel is collected in the sight
glass.
– As soon as the drain plug (2) has been loosened,
drain the accumulated amount of water and col-
lect it in a container.
– Observe the general warnings at the beginning of
the "Maintenance" chapter.
Environment!
Lubricants and fuels end up in the
environment.
Environmental pollution.
– Lubricants and fuels must be collected
and stored in suitable containers and dis-
posed of in a way that is harmless to the
environment and in accordance with
existing anti-pollution regulations.
17
Standard equipment
29516
18
Accessory
29517
1
1
WARNING:
Use of unpermissible spare parts or
lubricants.
Machine damage or increased wear.
– Spare parts and lubricants must at least
comply with the technical standards
required by the manufacturer of the
implement!
– The use of genuine CLAAS spare parts
and lubricants is recommended.
To Next Page
Loading...
