88 00 0293 210 2 - BA DOMINATOR 150/140/130 - 12/09
5 Prior to initial operation
5.1 General Information
67081
Chassis
– Fit the wheels.
– Check the tyre pressure and correct if necessary.
– Check condition and permissibility of tyres.
– If necessary adjust the rear axles / rear wheel
drive axles from transport position to working
position.
– If necessary adjust the wheel track for the given
tyres.
– Check tightening values of wheel fixing elements
and correct if necessary.
– Check oil level in all gearboxes and refill if
necessary.
Brake
– Check brake fluid level and top up if required.
Drives
– Check all belt tensions and adjust if necessary.
– Check all safety guards and put them into their
correct position, if required.
– Check oil level in all gearboxes and top up if
necessary.
Hydraulic system
– Check hydraulic oil level and tightness of hydrau-
lic system.
Electrical / electronic equipment
– Fill and charge battery, if required.
– Install fan / air conditioner fuse.
– If necessary, install side lights in case of excess
width.
Intake
– Remove the lift eyes.
– Fit mounting plates.
– Check the front attachment float springs.
– Align the coupling lugs (machines without Auto-
Contour)
Separation
– Remove the lift eyes.
Grain delivery
– Close the service aperture on the grain tank
unloading tube.
– Install the grain tank safety device.
– Putting the air conditioner into operation (with
Sanden compressor)
To Next Page
Loading...
