92 00 0293 210 2 - BA DOMINATOR 150/140/130 - 12/09
5 Prior to initial operation
5.2 Chassis
67081
– Jack up the machine a little at the rear until the
rear axle wheels only have slight ground
contact.
– Remove the right-hand ball joint of the track rod.
– Remove steering cylinder mounting bracket (1)
from the axle body.
– Slacken off the clamping bolts (2) on both sides.
– Unscrew mounting bolts (3) on both sides.
– Slide the adjustable axle sections in or out to
obtain the desired track width (2300 mm, 2500
mm, 2700 mm). Install mounting bolts (3), but do
not tighten them at this time.
– Tighten clamping bolts (2) first, then tighten
mounting bolts (3).
– Bolt down mounting bracket (1) in the correspond-
ing tapped holes.
– Set the wheels to zero toe-in by adjusting the
right-hand ball joint on the track rod. In order to
obtain accurate measurements, measure from the
inside edges of the rim, where the beading of the
tyres rests. Secure the track rod. Use new self-
locking nuts. Tightening torque = 140 Nm
5
19471
3
1
2
Danger!
Jacking up the machine.
Death or serious injury.
– Use jack / jack stand with sufficient
capacity.
– Use reliable jack / jack stand.
– Use jack / jack stand on solid and level
ground.
– Apply the jack / jack stand at the position
of the machine intended for this purpose.
To Next Page
Loading...
