Claas DOMINATOR 150 - Unlocking the Front Attachment; Unhitching Front Attachment

136 00 0293 210 2 - BA DOMINATOR 150/140/130 - 12/09
8 Mounting/removing front attachment
8.3 Removing the front attachment
67084
– Place universal drive shaft in holder (1).
– Hang in chains (2) as short as possible.
71365
8.3.5 Unlocking the front attachment
– Observe the general warnings at the beginning of
the Fitting / removing the front attachment
chapter.
– Pull out cotter pin (1).
– Pull lock pin (2) out of the feeder unit of the
machine, using lever (3).
– Shift lever (3) all the way to the outside and
secure in that position by means of cotter pin (1)
at (A).
only front attachments and machines equipped
with AUTO-CONTOUR:
– Pull out lever (1) and swing lever (2) up to
position (A).
Lever (1) does not engage in that position.
– Repeat this procedure on the other side of the
machine.
71375
8.3.6 Unhitching front attachment
– Observe the general warnings at the beginning of
the Fitting / removing the front attachment
chapter.
25
24506
1
2
2
26
19523
1
3
A
2
27
24849
A
1
2