EasyManuals Logo

Claas DOMINATOR 150 User Manual

Claas DOMINATOR 150
390 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #247 background imageLoading...
Page #247 background image
00 0293 210 2 - BA DOMINATOR 150/140/130 - 12/09 247
12 Faults and remedies
12.3 Front attachment
67088
12.3 Front attachment
87895
12.3.1 Front attachment
– Observe the general warnings at the beginning of
the "Trouble and remedy" chapter.
Malfunction Cause, remedy
Front attachment
Poor cutting action • Adjust the knife clip.
• Replace the knives.
• Align knife fingers.
• Replace any damaged knife sections and/or fingers.
• Remove build-up of foreign material from cutterbar.
The knife suddenly stops • Remove foreign objects.
• Replace damaged double fingers.
• Tension the knives drive belt.
Lodged crops not properly picked up • Check spacing of crop lifters.
• Adjust the reel further forward.
• Set reel fingers to »grabbing« position.
• If necessary, set the cutterbar skids inwards.
Dirt and material build up on divider points • Set the crop divider upwards at the adjusting plate.
• Use special crop dividers.
Cutterbar cannot be raised • Check fuse.
• Have hydraulic oil pressure checked.
Feeder chains and cutterbar stop too easily • Tension the cutterbar drive belt as specified.
• Have the feeder chain slip clutch adjusted.
• Have the cutterbar clutch checked.
The front attachment is in an oblique position
(machine without Auto-Contour)
• Check pressure of tyres.
• Align the front attachment mountings on the trough
suspension.
Cutterbar clutch will not disengage • Have the cutterbar clutch checked.
Uneven material flow • Correct reel speed and reel tine position.
• Correct reel horizontal position.
• Adapt intake auger height to material to crop.
• Adjust feed rake chains to correct tension.
Intake auger tending to stop or gets blocked • Turn intake auger back and remove foreign object.
• Have slip clutch reset to correct torque.
Crop wrapping round the reel shaft ends • Adjust the inner deflector properly.
Crop wrapping round the reel tine tubes • Slightly raise the reel.
• Incline the reel tine a little more to the front.
• Adjust reel speed to match ground speed.
• Cover up reel tine tubes.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Claas DOMINATOR 150 and is the answer not in the manual?

Claas DOMINATOR 150 Specifications

General IconGeneral
BrandClaas
ModelDOMINATOR 150
CategoryFarm Equipment
LanguageEnglish

Related product manuals