Claas DOMINATOR 150 - 10 Checking the Drive Axle Gearbox Oil Level

00 0293 210 2 - BA DOMINATOR 150/140/130 - 12/09 313
13 Maintenance
13.6 Chassis
67089
– Unscrew bolt (1).
– Fill in new oil.
– Check oil level , top up if necessary.
– Remove dirt from bolt (1).
– Screw in bolt (1) with sealant.
– Repeat this procedure on the other side of the
machine.
86771
13.6.10 Checking the drive axle gearbox oil
level
– Park the machine on level ground.
– Observe the general warnings at the beginning of
the "Maintenance" chapter.
WARNING:
Use of unpermissible spare parts or
lubricants.
Machine damage or increased wear.
– Spare parts and lubricants must at least
comply with the technical standards
required by the manufacturer of the
implement!
– The use of genuine CLAAS spare parts
and lubricants is recommended.
Caution!
Machine operation with unpermitted or pol-
luted lubricants.
Machine damage.
– Ensure a clean environment.
– Use suitable and clean tools.
– Use permitted lubricants.
– Lubricants must be free of pollution.
68
Right side
23393
1
Caution!
Machine operation with unpermitted or pol-
luted lubricants.
Machine damage.
– Ensure a clean environment.
– Use suitable and clean tools.
– Use permitted lubricants.
– Lubricants must be free of pollution.