316 00 0293 210 2 - BA DOMINATOR 150/140/130 - 12/09
13 Maintenance
13.6 Chassis
67089
86622
13.6.13 Adjusting the chassis clutch
DOMINATOR 130
– Observe the general warnings at the beginning of
the "Maintenance" chapter.
– Unhinge rods (1 and 2) at lever (3).
– Pull rod (1) to the outside until a resistance is
clearly felt and adjust the pre-set
dimension (C = 40 mm) from the inner edge of the
nut up to the side panel.
– Fit rods (1 and 2) to lever (3), using pin (4).
– Depress the clutch pedal until a clear resistance is
felt, measure the play (A = 7 - 11 mm) and adjust
at rod (1) if required. Note: The play should be set
to the upper tolerance limit (10 - 11 mm).
– Depress the clutch pedal to the maximum, meas-
ure the overall clutch path (B = 20±1 mm) and
adjust at rod (2) if required.
86746
13.6.14 Adjusting the short-circuit valve
DOMINATOR 130
– Observe the general warnings at the beginning of
the "Maintenance" chapter.
72
23386
2
1
C
73
23386
2
1
A
B
Caution
Incorrect installation of components.
Increased wear on components or machine
damage.
– The yokes (5) of rods (1 and 2) must not
touch lever (3) either when operated or
when in rest position.
– Observe the adjusting dimensions.
– Ensure that the overall clutch path
is (B = 20±1 mm).
To Next Page
Loading...
